+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: Side sizing. (/showthread.php?tid=7356441)
Side sizing. - janus frey - 07-06-2020
Stuff I don't need any longer. You pick up. You will need a friend with a strong back, but no stairs are involved.. $1500 for the entire package only. This is a bargain, so don't mess. I will not break it up. Sell whatever you don't want on Ebay when you get it home.
JET JSG-6, 12" disk 6x48 belt, currently wired for 220, but can be switched to 110 if you know what you are doing.. It is dual voltage. Not new by any means, but will take the skin off of your knuckles quite nicely.
Grizz G8479 pump sleeve sander , set up with dual air drums (6 & 4 inch)
Rockwell 46-111 lathe, on stand. 7" gap.
Delta 23-700 wet/dry grinder. Good for axes.
Orbit floor drill press, #2 MT chuck, 5/8" capacity. 12 speed. No crank rail, you have to muscle the table up and down.
Brand new craftsman 358 gas chain saw, 16", never started, with hard case.
PM me before Dom does.
RE: Side sizing. - Alan S - 07-08-2020
Where are you located?
RE: Side sizing. - 6270_Productions - 07-08-2020
"Location: West Chester PA"
Ask his father, West Chester.
RE: Side sizing. - janus frey - 07-08-2020
(07-08-2020, 05:57 AM)6270_Productions Wrote: "Location: West Chester PA"
Ask his father, West Chester.
My dad's dead. It may take a while for an answer from him.
