11-21-2017, 11:37 PM
If that is when I have change in my pocket....
[attachment=5872]
Little bit rusty, and krusty? Chisel's handle was in a different box.....seemed to fit the chisel, though.
[attachment=5873]
First saw the gear wheel's edge, I thought it might have been a Millers Falls No. 5 NOT. Name on the crank's handle says Defiance Made in USA....got it all cleaned up, oiled up, chuck loosened up....
[attachment=5874]
The four auger bits....one is a #5, the others are #4s....
[attachment=5875]
These were $1 a pair....in a coffee can full of bits. These were the sizes I needed.
[attachment=5876]
Close up of the gear drive. A few drops of 3in1 oil got things moving again.
Chisel is an 1-1/4" wide firmer chisel, logo says it is a "clearcut" brand....Hardware Store brand? I have a panel saw with the same logo...
$20 + sales tax......may have to return to that store......someday...
[attachment=5872]
Little bit rusty, and krusty? Chisel's handle was in a different box.....seemed to fit the chisel, though.
[attachment=5873]
First saw the gear wheel's edge, I thought it might have been a Millers Falls No. 5 NOT. Name on the crank's handle says Defiance Made in USA....got it all cleaned up, oiled up, chuck loosened up....
[attachment=5874]
The four auger bits....one is a #5, the others are #4s....
[attachment=5875]
These were $1 a pair....in a coffee can full of bits. These were the sizes I needed.
[attachment=5876]
Close up of the gear drive. A few drops of 3in1 oil got things moving again.
Chisel is an 1-1/4" wide firmer chisel, logo says it is a "clearcut" brand....Hardware Store brand? I have a panel saw with the same logo...
$20 + sales tax......may have to return to that store......someday...
Show me a picture, I'll build a project from that