Posts: 6,948
Threads: 0
Joined: Aug 2004
Location: Perth, Australia
Thanks Mound.
FWW contacted me to ask permission for this one. The previous (non shoptools edition) had a method I deviced for converting high sided bench chisels into dovetail chisels in about a minute, with little effort. I was rather proud of that one.
Link to the article is here:
http://www.inthewoodshop.com/ShopMadeToo...isels.html
Regards from Perth
Derek
Posts: 16,182
Threads: 2
Joined: Oct 1999
Nice job as always, Derek - thanks for the tip.
Doug
Posts: 12,283
Threads: 0
Joined: Mar 2006
Way to go Derek! I shall make a point of seeking a copy!
Posts: 6,948
Threads: 0
Joined: Aug 2004
Location: Perth, Australia
It's not a special photo. I was prepared to write an article on all the features of this vise, such as the clamping system, spring-loaded chop, etc. I think FWW missed the boat.
The details are here:
http://www.inthewoodshop.com/ShopMadeToo...Vise2.html
Regards from Perth
Derek