Posts: 999
Threads: 0
Joined: Apr 2001
Location: South West Pa.
Need a really good grease/oil dissolver for farm equipment. Have tried rattle can products from various auto stores. They just don't penetrate.There must be something better? Any first hand recommendations ?
Bill B
Posts: 5,058
Threads: 0
Joined: Jan 2014
Location: Santa Maria, Ca
Krud Kutter.
Recently tried it to clean a forty year old EGR valve. Worked great. And if it can dissolve all that baked on carbon/crud it will likely work for you too.
Mark Singleton
Bene vivendo est optimum vindictae
The Laws of Physics do not care about your Politics - Me
Posts: 999
Threads: 0
Joined: Apr 2001
Location: South West Pa.
Thanks Mark. Any idea if it will damage painted surfaces like mower decks etc.?
Bill
Posts: 13,412
Threads: 0
Joined: Jun 2004
Location: Texas
If it is caked on, I have the best results with a pressure washer, then use a cleaner to finish it up.
Mineral spirits can help dissolve thinner areas.
I like 409 to get the fine oily surface more clean.
Posts: 30,946
Threads: 2
Joined: Mar 2003
Location: Athens, TN
Steam pressure washer. Used to use them in fish restaurants cleaning the big fryers. Messy, but very effective.
Slightly expensive too.
Rocket Science is more fun when you actually have rockets.
"The Constitution is not an instrument for the government to restrain the people, it is an instrument for the people to restrain the government." -- Patrick Henry
Posts: 10,635
Threads: 0
Joined: Jul 2005
Location: Front seat on the Struggle Bus
Pure Simple green cut 1/3 with Ammonia...
Ed
Posts: 5,119
Threads: 12
Joined: Apr 2009
Location: SoMar
Super Clean in the purple bottle/jug cleans anything.
And I mean anything. But it removes or softens paint.
That may be an issue for someone.
Posts: 7,421
Threads: 1
Joined: Sep 2005
The engine cleaner products all work best when the engine is heated. I recall using Gunk to clean a car engine. The instructions said to get the engine block hot before spraying.
I suppose leaving the equipment in direct sunlight on a warm day would help or even tenting the equipment and using a kerosene heater for a couple of hours to warm up the castings would help. But the cleaners don't work well on cold surfaces and until you resolve that you won't have much luck.
There are heated pressure washers and that might be the answer.
No animals were injured or killed in the production of this post.
Posts: 1,529
Threads: 0
Joined: Jan 2007
Gunk that was the one I could not think of the name of. Been many years ago when I used that. Had a 1966 buick and a 1972 nova I used that on all the time. heat the engine let it sit and then wash it off with a hose.
Today Simple green is a very good cleaner. May take a couple coats but works well.
John T.
Posts: 5,732
Threads: 2
Joined: Dec 2004
Location: Fort Worth
Mr_Mike said:
Steam pressure washer. Used to use them in fish restaurants cleaning the big fryers. Messy, but very effective.
Slightly expensive too.
Yup pure steam or a steam pressure washer is best. That's how they clean heavy equipment and semi engines.
My next best would be a pressure washer with simple green or similar cleaner.