Tooth setting on 6tpi hand saw question
#15
a bit late, but i generally take the approach with old steel that the less bending the better. In the case of an overset saw I'd joint, sharpen and test. if the overset affected the cut, I'd stone some of it off.
Occasional musings on my blog:
bridgerberdel.wordpress.com
Reply
#16
On rip saws, the set is wider than a xcut.

I wouldn't worry about breaking anything I float them, sharpen and test.

If you're convinced they are over set, just reset them.

This is a rip saw so file the teeth straight across.
Reply
#17
Now I'm curious about my saw vise.  I have a 12" vise, yet I've seen Paul Sellers use a 30" wooden saw vise.  With the 12" vise I'd have to reposition the saw after a few teeth are sharpened but with Paul's method I could do the entire saw.  What do you guys use?

[Image: 20170418_151204_zpsv5dheew4.jpg]
Reply
#18
I bit the bullet and got this, one move for a full size saw, grips well:

https://www.toolsforworkingwood.com/store/item/GT-SAWV
Credo Elvem ipsum etiam vivere
Non impediti ratione cogitationis
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.