+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: Low temp glue? (/showthread.php?tid=7184248)
Low temp glue? - Roger A - 01-04-2016
Have a small project in the barn I need to glue up and it is cold! About 40 maybe a bit less, and that is with a small heater. What can i expect from TBIii at this temp? Any suggestions?
Re: Low temp glue? - Dennis Puskar - 01-04-2016
If I were you I would check with the manufacture.
I would say that it is a little to cold for the glue to work.
Re: Low temp glue? - Rob Young - 01-04-2016
40F is below the chalk temperature for TB-II. That is 55F.
TB-III has a chalk temperature of 45F which is getting closer to your working range.
But it does mean you should keep all the material being glued at or above (above is better) the chalk temperature for 24 hours. May not be possible as you describe your application.
Your best bet is probably to contact Titebond http://www.titebond.com/ directly and describe the situation and get their recomendation.
Re: Low temp glue? - JGrout - 01-04-2016
Quote:
What can i expect from TBIii at this temp?
failure
it is a small glue up, figure out enough space to take it in the house let it sit overnight then glue it up inside the house.
a tarp, plastic sheeting, spread out newspapers or whatever to cover the floor or table keep glue from ruining something.
Re: Low temp glue? - Roger A - 01-04-2016
They are four drawer boxes made from 1/2" ply with dada/rabbet locking joints. I guess i'll bring the parts in and let them warm up!
Roger
Re: Low temp glue? - Boatman53 - 01-04-2016
My shop is only marginally heated so I sometimes resort to this setup.
Jim
Re: Low temp glue? - Sawdustd - 01-05-2016
Critical point: The WOOD temp MUST be above 55 for the glue to work. Cold wood will result in joint failure. Make a "hole" in the house to work in. And --- you're going to need that same "hole" to apply the finish.
Re: Low temp glue? - fredhargis - 01-05-2016
I'd do what boatman suggested, though I have also used an electric blanket to keep the assembly warm till the glue sets.