Longevity of HFDC? - Printable Version +- Woodnet Forums (https://forums.woodnet.net) +-- Thread: Longevity of HFDC? (/showthread.php?tid=7330556) |
Longevity of HFDC? - Mike67 - 05-29-2017 Has anyone worn out a HFDC? I've had one for about a decade and it makes some squealing noises. Should I start looking for a replacement? Thanks. RE: Longevity of HFDC? - Alan S - 05-29-2017 If it's the bearings, those are replaceable. You can install better ones and they should last longer. There are detailed instructions on changing motor bearings to be found various places, including vintagemachinery here: http://wiki.vintagemachinery.org/Baldor%20Motor%20Repair.ashx Or use this as an opportunity to move more air with a bigger DC. RE: Longevity of HFDC? - daddo - 05-29-2017 You might find a round disk on the side opposite the shaft end that's part of the start circuit, place a little dielectric grease on it. Otherwise, it's a bearing and you might get lucky by oiling them with a 10 or 20 weight oil. RE: Longevity of HFDC? - Phil Thien - 05-29-2017 Probably a bearing but make sure the blower wheel is snug on the shaft (there are a couple of set screws, one stacked on top of the other). RE: Longevity of HFDC? - Mike67 - 05-30-2017 Thank you! |