08-13-2015, 08:25 AM
All of the photos I could find are of mounting a power feeder to a tablesaw or shaper and they are all bolted to holes drilled into the top. I have a few problems with that approach.
1- I don't really want to drill my cast iron tops
2 - I don't have a shaper so that doesn't really apply.
3 - my table saw has web (open) -wings...there is nothing to drill.
4 - I REALLY want the unit for the jointer. There is no surface available to drill without being in the way of the lumber passing through.
Has any used the universal feeder mount from Grizzly?
https://www.grizzly.com/products/Quick-Holder/G4175
Does anyone know if it will fit a Delta Power Feeder?
Finally, does any one have a picture of how they have mounted a stock feeder to their jointer?
P.S. I started a new thread so as to not commingle responses on mounting and finding parts. TIA
1- I don't really want to drill my cast iron tops
2 - I don't have a shaper so that doesn't really apply.
3 - my table saw has web (open) -wings...there is nothing to drill.
4 - I REALLY want the unit for the jointer. There is no surface available to drill without being in the way of the lumber passing through.
Has any used the universal feeder mount from Grizzly?
https://www.grizzly.com/products/Quick-Holder/G4175
Does anyone know if it will fit a Delta Power Feeder?
Finally, does any one have a picture of how they have mounted a stock feeder to their jointer?
P.S. I started a new thread so as to not commingle responses on mounting and finding parts. TIA