03-05-2019, 10:37 AM
I couldn't help myself last night at the BORG and picked up Dewalt 799 12" CMS. After I set it up on the stand, I noticed while at full extension and with the head pushed all the way down the blade slightly drags the casting underneath. It's only for an inch or so at the very end but that can't be right. Is there an adjustment for that? I haven't turned it on yet so I would imagine it would simply make a groove and that would be the end of it but I wanted to make sure I wasn't missing something.
Howard
The Dallas woodworker
"I didn't attend the funeral but I did send a letter approving of it"
Mark Twain
The Dallas woodworker
"I didn't attend the funeral but I did send a letter approving of it"
Mark Twain