#27
Here's the table my wife wants me to build for her...it's only taken a decade to get her to choose one!

I've already figured out the joinery connecting the semi-circles to the leg assemblies--floating tenons with drawbores for the clamping forces.  The semi-circles aren't load bearing, so the grain orientation isn't likely to cause any real troubles, but I'm thinking that each semi-circle should instead be made from three sections, which will allow the grain to flow a little better around the curves.  Final shape would be cut with template routing after gluing up the sections. 

What do you think?
Semper fi,
Brad

Reply

#28
Glue up the width you need, say 8"?, then lay both ends of the curved piece on one side of the glueup.
Steve

Mo.



I miss the days of using my dinghy with a girlfriend too. Zack Butler-4/18/24


 
The Revos apparently are designed to clamp railroad ties and pull together horrifically prepared joints
WaterlooMark 02/9/2020








Reply
#29
IMO, the arcs made in multi sections would look strange and it would over complicate your build. I think the arc in the upper left of your photo looks the best. I would find straight grained lumber like that or use quarter sawn and run the grain tangent to the midpoint of the curve as shown by the upper left arc.
The grain in the lower right is close, but not quite tangent to the midpoint of the arc and looks a little wonky.
Reply

#30
(09-11-2023, 09:25 PM)Willyou Wrote: I think the arc in the upper left of your photo looks the best. 
The grain in the lower right is close, but not quite tangent to the midpoint of the arc and looks a little wonky.

I agree, and IMHO, cherry will look much better than the oak.
"I tried being reasonable..........I didn't like it." Clint Eastwood
Reply
#31
Might be time to explore laminating and veneer.
Blackhat

Bad experiences come from poor decisions. So do good stories. 


Reply
#32
(09-12-2023, 06:50 PM)blackhat Wrote: Might be time to explore laminating and veneer.


I had actually thought about that, but I'll build this in cherry so the grain patterns won't be as prominent as the red oak used here. 

And since it's for our home, if it's not perfect, it'll be okay. 

I really should add a vacuum bag to my arsenal...
Semper fi,
Brad

Reply
#33
The basic approach looks to be very similar to that used when making a hayrake table.   Google hayrake table, and I believe you will find links to the FWW article on making one. 

I'd go with a single piece for each curve, rather than with laminations.  Think the assembly steps through well.
Reply
#34
Pretty sure those curved sections are laminated then a veneer applied to the outside of the curve. Otherwise, you'd have end grain exposed like near the bottom of the section on the near right side. I wouldn't be surprised if the table shown didn't use veneered ply. It's stained, so somewhat easier to match the outside veneer to the ply veneer.
Still Learning,

Allan Hill
Reply
#35
Use wood with less  dramatic figure.
Heirlooms are self-important fiction so build what you like. Someone may find it useful.
Reply

#36
(09-15-2023, 10:56 AM)hbmcc Wrote: Use wood with less  dramatic figure.


So, that doesn't address the question at all.
Semper fi,
Brad

Reply
How would you lay out these curves?


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.