Flag boxes again

[glennw]

I have to ask a stupid question guys. I can't remember the needed dimensions I have cut a flag box on before. Any help please so I don't waste the walnut

[clockman]

Here you go

http://www.diablowoodworkers.com/pdf/fla...uction.pdf

[Sawdustd]

The critical consideration is the size of the flag and the're many sizes thus when folded will require different dimensions . If at all possible, get your hands on the flag and fold it or ask whom ever you are making this for, the folded dimensions of the flag.

[glennw]

I have the flags ill be going about 18 inchs by 26 roughly. thanks

[Gary G™]

IIRC, the ID for the short side is 15-1/2" and 21-1/2" for the base for an honor flag.
Roughly 12-1/2" triangle height.

[glennw]

I meant to add to my last post its a 3x5 flag.

[Gary G™]

The 3 X 5 is smaller than the dimensions I posted, I haven't done that size.

[goaliedad]

Gary G™ said:

---

The 3 X 5 is smaller than the dimensions I posted, I haven't done that size.

---

There may be s source to find the folded die, but I woukd wait until I had the flags. This size is about half the size of a traditional memorial flag

[glennw]

Having issues with making the angle cut for the bottom right and left sides. For the bottom board and both sides what should I put the blade on for the cuts.

[glennw]

what angle do I cut the bottom angles where should I put the blade angle at for the bottom board and the bottom right and left corners. I have the top at 45 degrees