+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: Lumber source Tyler Tx? (/showthread.php?tid=7058114)
Lumber source Tyler Tx? - JDuke - 07-19-2015
I've been here for a while, but haven't found a good lumber supplier.
I'd like a steady supply of poplar for painted projects but also would like some nicer wood like cherry, maple,white oak and some basswood for a shutter project.
I know there are some folks in the area where do you get your wood for projects?
Duke
Re: Lumber source Tyler Tx? - RogerD - 07-19-2015
Duke,
Stuart Adams and Sons Hardwoods, 1501 South Buffalo Street, Canton, TX is the closest hardwood dealer to Tyler. I am also sending you a PM regarding our woodworking club in Tyler.
Roger Davis in Tyler, TX
Re: Lumber source Tyler Tx? - Bibliophile 13 - 07-19-2015
It's a ways from you, but M&G Sawmill is near Huntsville, and they can get some pretty good stuff.
Re: Lumber source Tyler Tx? - JDuke - 07-19-2015
Bibliophile 13 said:
It's a ways from you, but M&G Sawmill is near Huntsville, and they can get some pretty good stuff.
I've been to M&G several years ago, and their stock seemed pretty sporadic. Probably where I would go if I needed a couple hundred board feet for stain grade cabinets, but wouldn't drive down expecting basswood.
Duke
Re: Lumber source Tyler Tx? - JDuke - 07-22-2015
RogerD said:
Duke,
Stuart Adams and Sons Hardwoods, 1501 South Buffalo Street, Canton, TX is the closest hardwood dealer to Tyler. I am also sending you a PM regarding our woodworking club in Tyler.
Roger Davis in Tyler, TX
Went up there, great place, great staff, good selection.
Bought some 8/4 mahogany and some maple.
Thank you
Duke
Re: Lumber source Tyler Tx? - Bibliophile 13 - 07-23-2015
There's a difference between a sawmill and a lumberyard. M&G is a sawmill. They can mill up nice stuff, but they don't stock a lot of surplus lumber on a regular basis.