+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: Need advice - where to get a curved toolrest, for bowl making (/showthread.php?tid=7275330)
Need advice - where to get a curved toolrest, for bowl making - MidwestMan - 04-30-2016
I need one of those curved toolrests, so I can work on the inside of a bowl more easily.
The hassle of NOT having one, is too much.
Any recommendations from you guys?
Re: Need advice - where to get a curved toolrest, for bowl making - Wipedout - 04-30-2016
Robust
Re: Need advice - where to get a curved toolrest, for bowl making - Steve K - 04-30-2016
I have the Robust and it is well made and sturdy. Before you drop a hundred bucks or so however you should know they are much more effective for scraper work than for working gouges. The tool post can get in the way and makes them unhandy at times.
At about the 13 minute mark, Lyle Jamieson shows a technique in this video that looks weird but works surprisingly well.
Lyle Jamieson
Re: Need advice - where to get a curved toolrest, for bowl making - SteveS - 04-30-2016
I bought one of these S Curve and while it is good and stiff and has two threaded post holes, it is rather bulky and it would be nice to have something less bulky.
Re: Need advice - where to get a curved toolrest, for bowl making - AHill - 04-30-2016
+1. Just about every woodworking outlet sells them. Woodcraft and Craft Supplies USA, Packard Woodworks. You can even order them from Amazon. They make an inside and outside version.
Wipedout said:
Robust
Re: Need advice - where to get a curved toolrest, for bowl making - iclark - 04-30-2016
AHill said:
+1. Just about every woodworking outlet sells them. Woodcraft and Craft Supplies USA, Packard Woodworks. You can even order them from Amazon. They make an inside and outside version.
[blockquote]Wipedout said:
Robust
[/blockquote]
+1
The ones (not Robust) with the threaded post seem to always try to unscrew at the wrong time for me.
Re: Need advice - where to get a curved toolrest, for bowl making - MidwestMan - 04-30-2016
Thank you all for the responses. At this point, I am leaning towards getting the rest that SteveS has. it looks like the rest that will do the job the best. I'm making 6 to 8" outside diameter bowls, with about 3" of vertical wall and slightly convex.
SteveK, good video thank you. To be honest, that wouldn't work for me, my angles are a bit different and my tool rest isn't shaped like his, to do it.
Robust's "J" holder might not do the job as good as the holder SteveS suggests.
Thanks again guys. A power sander is next. I might as well order it as well.
Re: Need advice - where to get a curved toolrest, for bowl making - MidwestMan - 04-30-2016
Good heads-up about the post un-doing. I suspect now, that I will use lock tight to avoid that potential issue.
Re: Need advice - where to get a curved toolrest, for bowl making - MichaelMouse - 04-30-2016
MidwestMan said:
Good heads-up about the post un-doing. I suspect now, that I will use lock tight to avoid that potential issue.
Haven't had an unscheduled unscrew in twenty years on mine. Since I don't use it around the outside, I suppose I could have added loctite. If it becomes a problem, I will.
Re: Need advice - where to get a curved toolrest, for bowl making - chips ahoy - 04-30-2016
Bought mine at Lee Valley.
Mel