Flip-top tool stands - Printable Version

Flip-top tool stands - Printable Version

+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: Flip-top tool stands (/showthread.php?tid=7325866)

Flip-top tool stands - Jason28 - 12-04-2016

I see all kinds of flip-top tool stands in a Google image search. Does anyone have a preferred plan they used or images of one you just came up with? I'd like to build one and I'd like some first-person input on them. I've got a DeWalt planer and miter saw I'd be mounting for now, but I could have more in the future.

RE: Flip-top tool stands - Steve N - 12-04-2016

Both bulky heavyweights. I have not got one, but people I know who have made them seem to prefer the use of lighter tools. Not that the tools can't be secured, they just have said they practically lost an arm trying to slow it down after trying to change tools. If you are big an beefy with a lot of strength maybe not an issue?

RE: Flip-top tool stands - Jack01 - 12-04-2016

(12-04-2016, 07:41 PM)Jason28 Wrote: I see all kinds of flip-top tool stands in a Google image search. Does anyone have a preferred plan they used or images of one you just came up with? I'd like to build one and I'd like some first-person input on them. I've got a DeWalt planer and miter saw I'd be mounting for now, but I could have more in the future.

I have 3 flip top stand and they work well. One of them I had Dewalt Planner and other side was Rigid disk sander , worked well.
You just have to be careful when you flip, you gradually flip and yo will not have any issues. I have these stand for last 13 years .

few months ago I sold my Dewalt planner and purchased a planned /joiner combo unit. Now I will put something in place of the Dewalt planner.

Your Miter Saw may work, just make sure that the width of stand is higher than the depth of the Miter saw.

RE: Flip-top tool stands - Lynden - 12-05-2016

This stand is heavy duty and nicely built.

https://www.youtube.com/watch?v=g51OuJjcj84

RE: Flip-top tool stands - fredhargis - 12-05-2016

Wood magazine has done a couple of plans that seem to get really good reviews. You might check their article index.

RE: Flip-top tool stands - Bill Holt - 12-05-2016

I have two, but I have only one tool per stand. The reason: both stands (planer and SCMS) are stored under my TS out feed table. Both stands have "fold up/down" wings. I have no problem with the weight. I think the DW735 is 90 pounds and I guess DW SCMS at 65.

RE: Flip-top tool stands - gad5264 - 12-06-2016

Jason, check your private messages. I sent you some information.

RE: Flip-top tool stands - Edwin Hackleman - 12-07-2016

Mine works very well:

I can also roll it around the shop. See the casters underneath. They lift up using the cams, and the stand then locks into place, flat on the floor. Any ideas what I should mount underneath the thickness planer? It doesn't seem to care what winds up below.