+- Woodnet Forums (https://www.forums.woodnet.net)
+-- Thread: Irwin adj bit part (/showthread.php?tid=7329902)
Pages:
1
2
RE: Irwin adj bit part - bandit571 - 05-01-2017
Ok, which bolt did yours wind up using?
Used my drill bit a little while ago, when I added the dowel to the side of the saw til. Didn't feel like digging around for the #14 sized bit. I just adjusted the expansive bit to match the dowel, and drilled away.
have to watch out, as some of these styled bits use a geared bolt head, to make size adjustments, You'd turn the bolt to change the width of the cut. Gear teeth on the slider and the bolt.
RE: Irwin adj bit part - RB61 - 05-11-2017
Got sidetracked for a while. It is 1/4 x 28. Local corner hardware store had it but only in allen wrench head. For general information, Lowes does not stock this thread. looks like I will not be able to spend my money locally- again. Next move is the the internet.
RE: Irwin adj bit part - mad_planter - 05-12-2017
Is there a fastenal around? They've got brick and mortar locations all over. They tend to be in out of the way places as they don't really depend on foot traffic.
RE: Irwin adj bit part - RB61 - 05-12-2017
I think I found it in their catalog. I have seen one of their stores locally. Hope I don't have to buy a 100.
Thanks to everyone for their help. If this doesn't work out, I will get the hacksaw out and work on the allen head one.
Ray