saw till creation - Printable Version +- Woodnet Forums (https://www.forums.woodnet.net) +-- Thread: saw till creation (/showthread.php?tid=7341885) Pages:
1
2
|
saw till creation - mongo - 08-21-2018 Rather than complain about the lack of traffic. Here is a build along. forgive me I got started before I decided to document. but there is lots more to come. Years back I built a sawbench, till combo. I think the guy who I copied the idea from was badger woodworks but I could be wrong. It worked great at protecting my saws. But it always ended up with stuff on it so every time I needed a saw I had to move everything or use a electron driven demon. Forgive me this is my first run with the new update I am having issues with photos... RE: saw till creation - Stwood_ - 08-21-2018 I'm in... ............. RE: saw till creation - mongo - 08-21-2018 Here is a view of the inside. Some saws are out. I also have some pull saws hanging out elsewhere. RE: saw till creation - mongo - 08-21-2018 Here is the cabinet in question- Gotta figure out why it keeps changing the orientation of my images. Anyone have any idea RE: saw till creation - mongo - 08-21-2018 Dog got bit by a snake last week so he still requires lots of supervision. He has been in bed for a few days so he was happy to sit in the shop while I made a small stand and a notched bracket for the longer saws with hand tools. I will probably remake both of these nicer if the plan works out. Got a rough fit for my larger saws RE: saw till creation - paarker - 08-22-2018 I am going to have to borrow that pull saw idea of yours. Seems like an easy project I may need to do tomorrow. RE: saw till creation - mongo - 08-22-2018 (08-22-2018, 05:23 PM)paarker Wrote: I am going to have to borrow that pull saw idea of yours. Seems like an easy project I may need to do tomorrow. Parker, borrow away. Add a lip to the base so they dont back off. That would be the the only change I would make if I wasnt moving the saws. RE: saw till creation - mongo - 08-22-2018 Had a little time before work today to start on the second half of the till prototype. I found two piece of scrap and a cut down a dowel for the next stand piece. Since the scrap was on the short side I put the dowel on top. To cut the flats I marked with a drill bit for an even hieght. Since this is just prototype I just nailed the dowel in with a couple cut nails. RE: saw till creation - Bill_Houghton - 08-22-2018 Lots of good ideas, starting with using your saw bench for the till. Or the till for a saw bench. Keep the tools near where they'll be used. RE: saw till creation - bandit571 - 08-23-2018 Hmmm...wonder IF I need to build a door (s) onto my saw til? [attachment=12465] Might have out grown mine? 2 compass saws are hanging onto the top around back, and 4 panelsaws on the side,,,,not enough room for the other backsaws... [attachment=12466] So I just keep them hanging around. Saws are as bad as planes....or rabbits? Can never stop after just one..or two...or... |