+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: Quest machine found! 12" Clement jointer (/showthread.php?tid=7342524)
RE: Quest machine found! 12" Clement jointer - ®smpr_fi_mac® - 10-14-2018
I added a dust chute and pulled the cutterhead from the machine. Two cleats are screwed to the inside of the base. 1/2" ply sits on top. 1/4" ply ramps will hopefully help direct chips down. Rockler Dust Right fitting and elbow.
There are four bearings total, two on each side. Bearing is labeled 6206RS1. I've reached out to Accurate to spec out equivalent self aligning bearings.