Need bigger hole - Printable Version +- Woodnet Forums (https://www.forums.woodnet.net) +-- Thread: Need bigger hole (/showthread.php?tid=7346390) |
Need bigger hole - Gurubandhu - 02-12-2019 I have some 3/4 " holes in 3/4"thick wood. I need to make 1" holes to enlarge. I tried a spade bit but the spade ws all over the place. What do people recommend to use instead or that I do differently? Thanks, GB RE: Need bigger hole - Handplanesandmore - 02-12-2019 Not clear what you want to achieve. Are you trying to enlarge existing 3/4" holes to 1" holes, or drilling new 1" holes? In any case, use a Forstner bit, not a spade pint bit. If enlarging, use a 3/4" bit to center the stock on your drill press, replace the 3/4" bit with a 1" F.B., and redrill to enlarge. Simon RE: Need bigger hole - jteneyck - 02-12-2019 (02-12-2019, 12:49 PM)Gurubandhu Wrote: I have some 3/4 " holes in 3/4"thick wood. I need to make 1" holes to enlarge. I tried a spade bit but the spade ws all over the place. What do people recommend to use instead or that I do differently? Thanks, I plug the holes, then redrill. Another way is to make a template and route them larger with a router. John RE: Need bigger hole - ez-duzit - 02-12-2019 You can use a step drill to create a pilot hole for a 1" bit. Or clamp an alignment jig with a 1" hole over the existing hole. RE: Need bigger hole - Phil Thien - 02-12-2019 Use a rabbet but with bearing to increase to 1” from one side, then a flush trim bit to do the other side. RE: Need bigger hole - fishhh4 - 02-12-2019 Step drill bit with one inch max diameter. Just an idea.... RE: Need bigger hole - oakey - 02-12-2019 i plug them like john stated 3/4 dowel and re drill one inch i do not even glue the dowel in as long as they are snug lots of great suggestions any one will probably work out for you RE: Need bigger hole - Roly - 02-12-2019 (02-12-2019, 01:15 PM)ez-duzit Wrote: You can use a step drill to create a pilot hole for a 1" bit. Or clamp an alignment jig with a 1" hole over the existing hole. On this order. Clamp the alignment board with a one inch hole and use a hole saw. Roly RE: Need bigger hole - Gurubandhu - 02-12-2019 I agree/ There are lots of good suggestions. I do not have the bits people suggested like a Forsner or step drill bit. amd I do not have a drill press (and cannot use a drill press on it since it is way too big) I will go to the big box store and choose. Thanks for the suggestions. RE: Need bigger hole - ez-duzit - 02-12-2019 You don't need to go to the store to make an alignment jig from a scrap of wood. Drill a 1" hole through the scrap and clamp it over your workpiece. |