+- Woodnet Forums (https://www.forums.woodnet.net)
+-- Thread: folley belsaw planer (/showthread.php?tid=7346489)
folley belsaw planer - wing nut - 02-16-2019
Has any one ever replace the feed rollers on a folley belsaw planer I have the 9103, if so what are the steps
thanks
RE: folley belsaw planer - Stwood_ - 02-16-2019
Been a long time, don't remember the steps but it was fairly easy.
Put some new springs in there while yer at it.
Those like to accumulate gunk and wood chips under the roller attachment area (brass block). Need to keep that area cleaned out, or you'll loose some feed roller pressure.
RE: folley belsaw planer - DFJarvie - 02-16-2019
Some of the gears may need to come off. Before you remove anything take pictures of the planet together and as you take each piece off. This way you have a reference when you put it back together.
I tore mine down and replaced the cutterhead bearings, painted it and cleaned it. Its loud but works great.
RE: folley belsaw planer - Bob Vaughan - 02-16-2019
Try these threads.
http://www.owwm.org/viewtopic.php?f=1&t=143202
http://www.owwm.org/viewtopic.php?f=1&t=128792&hilit=bellsaw&start=15