+- Woodnet Forums (https://www.forums.woodnet.net)
+-- Thread: Software need for laser engraver (/showthread.php?tid=7351403)
Software need for laser engraver - teaberry - 11-23-2019
I just became the owner of an Artsign JSM-40U laser engraver... It is a used machine in good condition, but the software for the computer didn't come along. Can anyone help me find software for this machine? I have looked without any success...
RE: Software need for laser engraver - RPE1 - 11-25-2019
Those Chinese machines can/are troublesome. I don't know if it runs RD Works or not. Go here, join and ask your question, as you're gonna have lots of them trying to get it to run. Very helpful people.
https://rdworkslab.com
RP
RE: Software need for laser engraver - Shaun - 11-29-2019
That is basically the generic K40 laser.
I would try here: http://www.scorchworks.com/K40whisperer/k40whisperer.html This is free software, but is better than what originally comes with the machine (a modified stolen Corel package)
If that doesn't work for you, and you are thinking about upgrading at all, try here: https://lightburnsoftware.com/ but you may need to upgrade your control board. I am using a Cohesion3D setup in a similar laser and the improvement is massive. https://cohesion3d.com/shop/controllers/cohesion3d-laserboard/