+- Woodnet Forums (https://www.forums.woodnet.net)
+-- Thread: Show us your Roubo - Square that is... (/showthread.php?tid=7356035)
Show us your Roubo - Square that is... - C. in Indy - 06-18-2020
I'll bet a lot of us enjoy these little projects.
Here's my latest. It's oak on the bottom, locust on the upright. I'd like to see yours, too!
[attachment=27711]
Chris
RE: Show us your Roubo - Square that is... - Derek Cohen - 06-19-2020
No one else? Chris this is in the same (sort of) vein ... Large lay out square.
![[Image: C9494-C00-AEEE-4-F53-AFEC-4-B9-A17-E171-FB.jpg]](https://i.postimg.cc/mkc6G7S9/C9494-C00-AEEE-4-F53-AFEC-4-B9-A17-E171-FB.jpg)
![[Image: 86-C9-EFBD-5-BA5-4-BE6-8-A60-112-BAA977-E47.jpg]](https://i.postimg.cc/90vgXzxn/86-C9-EFBD-5-BA5-4-BE6-8-A60-112-BAA977-E47.jpg)
![[Image: 0-C828759-58-EF-40-F2-91-AD-045-E7283-F436.jpg]](https://i.postimg.cc/qBY5xZkx/0-C828759-58-EF-40-F2-91-AD-045-E7283-F436.jpg)
Regards from Perth
Derek
RE: Show us your Roubo - Square that is... - MarkSingleton - 06-19-2020
Nice work gents. Both are on my list. Even just as a wall hanger, a layout square looks so gosh darn
old school "serious" wood worker!
RE: Show us your Roubo - Square that is... - toolmiser - 06-20-2020
On my list also, just for the fun of it.
RE: Show us your Roubo - Square that is... - Phil S. - 06-21-2020
Derek -
Are the joints in the layout square lap joints?
Phil
RE: Show us your Roubo - Square that is... - Derek Cohen - 06-21-2020
(06-21-2020, 01:00 AM)Phil S. Wrote: Derek -
Are the joints in the layout square lap joints?
Phil
They are half-lap joints.
Here is Chris Schwarz's version: https://www.popularwoodworking.com/projects/english-layout-square-2/
... and if you scroll down, Chris comments on mine: https://www.popularwoodworking.com/woodworking-blogs/cool-square-but-what-the-heck-is-it-used-for/
Regards from Perth
Derek
RE: Show us your Roubo - Square that is... - C. in Indy - 07-12-2020
I've been meaning to finish one more oak+locust square, but I got distracted with the offcuts.
The inlay was done with my LV cutting-gauge. I don't have a use for this new panel, other than liking it!
- Chris
[attachment=28235]