+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: Congrats Derek Cohen (/showthread.php?tid=7371116)
Congrats Derek Cohen - mound - 10-27-2022
Opened up the latest FWW (Tools & Shops addition) and I see a beautiful Moxon Vice I recognize:
https://forums.woodnet.net/showthread.php?tid=7350402
Congrats!
RE: Congrats Derek Cohen - Derek Cohen - 10-28-2022
Thanks Mound.
FWW contacted me to ask permission for this one. The previous (non shoptools edition) had a method I deviced for converting high sided bench chisels into dovetail chisels in about a minute, with little effort. I was rather proud of that one.
Link to the article is here: http://www.inthewoodshop.com/ShopMadeTools/BenchChiselsintoDovetailChisels.html
Regards from Perth
Derek
RE: Congrats Derek Cohen - Tapper - 10-28-2022
Nice job as always, Derek - thanks for the tip.
Doug
RE: Congrats Derek Cohen - Tony Z - 10-29-2022
Way to go Derek! I shall make a point of seeking a copy!
RE: Congrats Derek Cohen - Handplanesandmore - 10-29-2022
(10-29-2022, 06:30 AM)Tony Z Wrote: Way to go Derek! I shall make a point of seeking a copy!
Or you can find check out all the current and past pieces here---- https://www.finewoodworking.com/gallery
Simon
RE: Congrats Derek Cohen - Derek Cohen - 10-30-2022
It's not a special photo. I was prepared to write an article on all the features of this vise, such as the clamping system, spring-loaded chop, etc. I think FWW missed the boat.
The details are here: http://www.inthewoodshop.com/ShopMadeTools/TheLastMoxonVise2.html
Regards from Perth
Derek