05-23-2021, 03:16 PM
I recently got a good deal on a John Fray Spofford 112 Bit Brace. I’ve read a lot about how well these work, so I grabbed it.
I was curious about bits for it. Can I just use a standard Irwin/Jennings auger set? Is there an older type of auger bits that were used with this brace? Any information would be greatly appreciated!
I was curious about bits for it. Can I just use a standard Irwin/Jennings auger set? Is there an older type of auger bits that were used with this brace? Any information would be greatly appreciated!