Posts: 281
Threads: 0
Joined: Jul 2010
If you intend to use it for sawing, no higher than your knee.
If you intend to use it for sitting, chair seat height will do.
The oak should be plenty thick enough, although it will be difficult
to bore by hand. If it was me, I would make it a lamination.
Bore the lower (underside) first and use it as a guide for the top half.
You could even through bore if you laminated on a seat layer.
Pictures, please. This will be an interesting project.
Lastly - isn't there some guideline about grain orientation on the legs?
There's considerable splay force on tenons that long.
Posts: 711
Threads: 0
Joined: Oct 2007
Location: N. Illinois
1. The height depends entirely on what is comfortable for you. Find something in your house or yard (a chair, a bench, a big rock…) that feels right for sawing or sitting or stepping up on – or whatever you plan to do with your staked project – and use that as a guide for height.
2. I did a staked shaving horse out of 2” pine construction lumber. I used battens to increase the thickness. With oak, you might be ok with just the 1 ½”.
3. Splay angle: If the legs angle too far outside the profile of the top, they become a tripping hazard for folks walking past. (Or maybe that’s just my own clumsiness.) Make a half-size model or do several drawings and play around with the leg angles.
Sounds like a fun project.
Mike B.
One thing is for certain though. Whichever method you use, you can be absolutely certain that you are most assuredly doing it wrong. Axehandle, 2/24/2016
Do not get in to much of a hurry buddy... Arlin, 5/18/2022
Apology excepted. TT. 2/25/20223
Posts: 145
Threads: 0
Joined: Nov 2011
St. Roy just did a staked chair build that you might want to
watch. He is using "about" a 1:4 ratio, and insetting the legs 2" - basically enough that they won't be outside the chair's edge and present a trip hazard.
I'll admit to being curious about some staked furniture also - anyone have a tapered reamer that they would like to send my way?
Posts: 1,464
Threads: 0
Joined: Mar 2008
I use a 14 degree splay. I like a 19 inch sawing bench. You might adjust 1/4 inch or so for each inch you are different from 5'9". Chair height has traditionally been around 17 3/4, which would not be unreasonable for a saw bench as well.
An inch and a half is fine for the top, however 18th century benches often had a short stretcher between end legs and a middle stretcher between the two end stretchers. I like the stretchers high enough that my shoe can go underneath.
I have been researching historic woodworking and making this type of bench since the 1970s but never heard the term "staked saw bench" or "staked stool" before. Do you know the origin?
Warren
Posts: 10,118
Threads: 0
Joined: Sep 2006
Location: South Alabama
a 1 1/2" thick top is just barely thick enough. 2" would be ideal, but you'll probably be okay.
Actual saw benches should be just a little lower than your kneecap. You want to be able to comfortably put one knee on a 2" thick piece of wood on top of the saw bench while your other foot rests comfortably on the floor.
Steve S.
------------------------------------------------------
Tradition cannot be inherited, and if you want it you must obtain it by great labour.
- T. S. Eliot
Tutorials and Build-Alongs at
The Literary Workshop