01-21-2016, 08:51 PM
I would like to attach a chuck to a baldor dental lathe. Then I can use the chuck along with a flexible shaft, for sanding.
Baldor has a version that is a bit pricey, and I'm looking for a more reasonalble alternative.
The specs are mounting hole .37" tapered .25" per foot.
I coudn't find where this equates to any common morse or jacobs taper.
Does anyone know the common name for this taper ?
Baldor has a version that is a bit pricey, and I'm looking for a more reasonalble alternative.
The specs are mounting hole .37" tapered .25" per foot.
I coudn't find where this equates to any common morse or jacobs taper.
Does anyone know the common name for this taper ?
My .02
Karl
Karl