02-02-2016, 02:53 PM
Can anyone ID this VS drive? The data label was painted over and all the markings came off as I tried to clean it.
It came on the Vega 1553 I'm putting back to work. It appears to have been added to the machine judging from the rough cut opening for it to move along on the leg of the lathe.
How do you operate it? The pulley on the headstock is fixed so I'm assuming the belt tension adjusts the size of the pulley thus changing the speed.
Any ideas?
It came on the Vega 1553 I'm putting back to work. It appears to have been added to the machine judging from the rough cut opening for it to move along on the leg of the lathe.
How do you operate it? The pulley on the headstock is fixed so I'm assuming the belt tension adjusts the size of the pulley thus changing the speed.
Any ideas?
"Truth is a highway leading to freedom" --Kris Kristofferson
Wild Turkey
We may see the writing on the wall, but all we do is criticize the handwriting.
(joined 10/1999)
Wild Turkey
We may see the writing on the wall, but all we do is criticize the handwriting.
(joined 10/1999)