01-17-2017, 04:23 PM
Evidently, years ago, which was the last time I used my LN 62, I sharpened a slight skew into the cutting edge. It's out of square enough to be throwing off my efforts to joint the small boards I'm working on. Just ahundreth of an inch or so.
Probably what happened is that I didn't have it seated squarely in my sharpening jig (Veritas MKII).
Will I be able to sharpen it back into square just by ensuring it is seated properly the next few times? Or is this a job for Mr. Grinder?
FYI, I don't want to use Mr. Grinder if I can at all avoid it, as I made a giant mess out of the last plane blade I tried to grind (fortunately, it was an old stanley No. 4 that I don't really care about).
Probably what happened is that I didn't have it seated squarely in my sharpening jig (Veritas MKII).
Will I be able to sharpen it back into square just by ensuring it is seated properly the next few times? Or is this a job for Mr. Grinder?
FYI, I don't want to use Mr. Grinder if I can at all avoid it, as I made a giant mess out of the last plane blade I tried to grind (fortunately, it was an old stanley No. 4 that I don't really care about).
If you're gonna be one, be a Big Red One.