Posts: 3,718
Threads: 0
Joined: Nov 2010
Ok...tore it down to just ..parts
[attachment=11881]
First surprise was the front knob was a Millers Falls one....happen to have a spare Stanley one...
[attachment=11882]
This was a bit better.....type 11 / 12 base....no pitting, no cracks...
[attachment=11883]
Small parts seemed to match up with the base sating. That chipbreaker even has the underside a blue colour...Iron may be almost the only "new" parts
[attachment=11884]
Well other than the front handle..and this lever cap....
[attachment=11885]
Frog seemed to be correct.
To be continued....
Show me a picture, I'll build a project from that
Posts: 3,718
Threads: 0
Joined: Nov 2010
Went ahead and sharpened the iron.....got the chipbreaker to sit up close to the edge. Iron's back needed flattened. Went to assemble everything back together..
[attachment=11886]
For some reason...mouth opening didn't ......was too tight...I even backed the frog back a bit....nada. Turned out, the iron was a bit thicker than the plane needed....I also backed the chipbreaker back from the edge a bit. Filed the front of the opening a bit. Picture above is the result....it will cut, no chatter.
[attachment=11887]
Gives me two smoothers, with the grooved bottoms..
[attachment=11888]
The Stanley #4c was a Made in England
[attachment=11889]
So...may just keep this No. 3 c around?
[attachment=11890]
In case the rest of the Type 11 parts show up...
Show me a picture, I'll build a project from that
Posts: 428
Threads: 0
Joined: Dec 2002
$30 +! Wow I'm used to seeing prices from you in the $2 to $3 range! :-) I love type 11 / 12 plane's!
Posts: 1,150
Threads: 0
Joined: Nov 2006
Location: Texas - Gods Country
Love #3's. Also love corrugated bottoms. They tune up so well as they are so easy to "flatten".
Nice find, and thanks for sharing.
Posts: 3,718
Threads: 0
Joined: Nov 2010
BTW....the plane hanging around in the background? A Sargent made Dunlap #3 sized, smooth soled plane..
[attachment=11892]
Happen to have a few planes in the #3 size range
Show me a picture, I'll build a project from that
Posts: 10,118
Threads: 0
Joined: Sep 2006
Location: South Alabama
Sweet! I found one similar a year or so ago. I cleaned it up intending to sell it, but then after trying it out, I just couldn't put it down. It's become a regular user in my shop.
Great buy, and a nice clean-up job to boot. Well done!
Steve S.
------------------------------------------------------
Tradition cannot be inherited, and if you want it you must obtain it by great labour.
- T. S. Eliot
Tutorials and Build-Alongs at
The Literary Workshop
Posts: 5,009
Threads: 0
Joined: Jan 2014
Location: Santa Maria, Ca
Good find. Well done.
Mark Singleton
Bene vivendo est optimum vindictae
The Laws of Physics do not care about your Politics - Me
Posts: 3,718
Threads: 0
Joined: Nov 2010
Small box project...been using this "new" plane for a lot of the work..
[attachment=11973]
Flattening glued up panels.....with ease
[attachment=11974]
To making raised panels...
[attachment=11975]
Even jointed an edge or two, after I had to trim the panels to size. Then did the raising
Been doing decent enough work in Maple.
Show me a picture, I'll build a project from that
