12-14-2018, 02:15 PM
Gents, I need to make a thicker board. These will be 7" wide, paduak. The "top" board will be quartersawn, the "bottom" will be flatsawn - because these are what I have.. Both 1" thick, glued face to face to make 7" by 2" thick board.
Foresee an issue here? Or is the difference between the flatsawn and quarter sawn expansion rates (1.9% net) small enough to be okay? Was also thinking about using epoxy, as it has a bit of flex to it.
Foresee an issue here? Or is the difference between the flatsawn and quarter sawn expansion rates (1.9% net) small enough to be okay? Was also thinking about using epoxy, as it has a bit of flex to it.
MAKE: Void your warranty, violate a user agreement, fry a circuit, blow a fuse, poke an eye out... www.makezine.com
No Good Deed Goes Unpunished
No Good Deed Goes Unpunished