Posts: 686
Threads: 0
Joined: Apr 2003
(07-07-2019, 05:30 PM)®smpr_fi_mac® Wrote: My 3/8" impact driver at ~150psi can't make it budge. Note that I'm not actually pulling on the pulley--it's loose. The piece that mounts between the pulley and shaft won't come off.
Advice?
Try to heat just the taper lock hub with a torch to expand it and break the rust lock.
Posts: 4,973
Threads: 0
Joined: Jan 2014
Location: Santa Maria, Ca
Yup. Propane torch ( flame wrench ).
Mark Singleton
Bene vivendo est optimum vindictae
The Laws of Physics do not care about your Politics - Me
Posts: 10,278
Threads: 1
Joined: Nov 2001
Location: Prince Frederick, MD
Duh.
I knew this.
At some point in the past!
Semper fi,
Brad
Posts: 765
Threads: 0
Joined: Jan 2011
Location: Cincinnati
(07-07-2019, 05:30 PM)®smpr_fi_mac® Wrote: My 3/8" impact driver at ~150psi can't make it budge. Note that I'm not actually pulling on the pulley--it's loose. The piece that mounts between the pulley and shaft won't come off.
Advice?
Are any of those holes threaded? If so, insert a bolt or bolts, and use them to push it off.
Lubrication is always better than dry. Automatic trans fluid works good in that situation.
Posts: 14,371
Threads: 1
Joined: Dec 2006
Location: Traverse City MI
PB Blaster would be my first try. And heat
Posts: 23,841
Threads: 2
Joined: Sep 2003
Location: Missouri
I'd let it soak for a while. TF or penetrating oil....
Then a hard rap on the puller shaft after it's tightened up.
Then some heat as suggested above if that fails.
Steve
Missouri
The Revos apparently are designed to clamp railroad ties and pull together horrifically prepared joints
WaterlooMark 02/9/2020
Posts: 22,459
Threads: 0
Joined: Feb 2005
Location: Regina Saskatchewan Canada
Cut a block of scrap wood that will slide under the hub and support it. With the block in place, tap a small cold chisel into the slot in the hub, rotate the hub and repeat in the other slot. Might have to do this a couple times on each side. Penetrating oil into the slots.
Blackhat
Bad experiences come from poor decisions. So do good stories.
Posts: 63
Threads: 0
Joined: Aug 2016
(07-07-2019, 05:30 PM)®smpr_fi_mac® Wrote: My 3/8" impact driver at ~150psi can't make it budge. Note that I'm not actually pulling on the pulley--it's loose. The piece that mounts between the pulley and shaft won't come off.
Advice?
Soak it with "Kroil" or as one of my maintenance men called it 'Panther pee" Best I have ever used.
Posts: 17,238
Threads: 0
Joined: Jul 2006
Location: Milwaukee area
A wise man once asked me, "are you sure it is supposed to come off of there?"