08-07-2019, 02:53 PM
I am in the process of installing a 3/4" 3 TPI Timberwolf blade in my saw. The saw will be used for general purpose ripping of domestic hardwoods and possible resawing and veneer slicing. The saw is currently set to run @ 3500 FPM vs its other speed of 1700 FPM. I really need to pick one speed and stick with it since a) speed adjustment requires loosening motor which requires disassembly of dust collection that took me an entire day to assemble and b) I really cannot get down that low and do much of anything.
If I only cut wood am I OK staying at 3500? The manual suggests slow speed for "super dense exotics." Veneer slicing might involve exotics.
Thanks again guys
If I only cut wood am I OK staying at 3500? The manual suggests slow speed for "super dense exotics." Veneer slicing might involve exotics.
Thanks again guys
Thanks, Curt
-----------------
"Life can only be understood backwards; but it must be lived forwards."
-- Soren Kierkegaard
-----------------
"Life can only be understood backwards; but it must be lived forwards."
-- Soren Kierkegaard