#8
  
I just received a moderate sized order for Beer Tap Handles from a local microbrew/distributor. I'd delivered them a prototype finished with Watco Laquer but wonder how the finish will hold up long term to the "alcohol rich" environment around a beer tap. Would there be something better to finish them with?

Prototype was 5/4 quarter sawn white oak.
Woodnets Certificate will expire on Sunday, August 2, 2020 at 8:08:11 AM EDT
Reply

#9
  Beer Tap Handles Gary™ I just received a mo...
(09-12-2019, 06:51 AM)Gary™ Wrote: I just received a moderate sized order for Beer Tap Handles from a local microbrew/distributor.  I'd delivered them a prototype finished with Watco Laquer but wonder how the finish will hold up long term to the "alcohol rich" environment around a beer tap.  Would there be something better to finish them with?

Prototype was 5/4 quarter sawn white oak.

Its going to take something that will withstand both the alcohol, the water/cleaning solution and LOTS of hands. I would think an epoxy finish would be your best bet.
Reply
#10
  Beer Tap Handles Gary™ I just received a mo...
NC Lacquer just isn't all that durable, it's a thin finish with fewer solids than some others. For this application maybe consider some form of catalyzed finish.
I started with absolutely nothing. Now, thanks to years of hard work, careful planning, and perseverance, I find I still have most of it left.
Reply
#11
  Beer Tap Handles Gary™ I just received a mo...
If it were me I'd just make them all out of African blackwood and skip the finish. It's impervious to water damage so no finish needed.
Cellulose runs through my veins!
Reply
#12
  Beer Tap Handles Gary™ I just received a mo...
Cheap and pretty good would be varnish like Waterlox, Arm-R-Seal, etc.  Expensive but really good would be a 2 part polyurethane.  Epoxy is good but yellows with exposure to UV unless it has stabilizers in it.


John
Reply

#13
  RE: Beer Tap Handles jteneyck Cheap and pretty goo...
(09-12-2019, 12:55 PM)jteneyck Wrote: Cheap and pretty good would be varnish like Waterlox, Arm-R-Seal, etc.  Expensive but really good would be a 2 part polyurethane.  Epoxy is good but yellows with exposure to UV unless it has stabilizers in it.


John

Hadn't considered Arm-R-Seal for this project but I've used that before with good results. I've done epoxy finish on a cedar strip canoe and it's too much $$$/time for this project. I've only allocate 12 minutes each to sand and finish each in the bid.
Woodnets Certificate will expire on Sunday, August 2, 2020 at 8:08:11 AM EDT
Reply
Beer Tap Handles


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.