12-08-2019, 11:49 AM
(This post was last modified: 12-08-2019, 11:57 AM by Philip1231.)
Trying to figure out how I am going to mount a new Westcott mortising chuck on the end of the cutter spindle on a Minimax FS41E jointer/planer. Here is picture of what am dealing with. I am told that the inner disc/bolt with the hex recess is supposed to screw out of the spindle, but it does not seem to want to (I have loosened the set screws). If you look toward the back of the hex recess, you will see what looks like something that has been mushroomed over so to speak: any idea what is going on there?
[attachment=22159]
[attachment=22159]