#5
This concept is not original, but I breathed on it to make it adjustable and rigid in use.

This is the basic design ...

[Image: 1a.jpg]

The legs can open to 24" and close down to near nothing ...

[Image: 3a.jpg]

The arms slide in wide mortices, and are held by screwed clamps into threaded inserts ...

[Image: 4a.jpg]

To complete the build, the legs are covered in cork-rubber. This protects the inside of a drawer. It has the extra benefit of being a superb non-slip.

[Image: 5a.jpg]

In use ...

[Image: 6a.jpg]

[Image: 7a.jpg]

Regards from Perth

Derek
Articles on furniture building, shop made tools and tool reviews at www.inthewoodshop.com
Reply

#6
Derek, in the last pic it looks like the bottom is secured by nailing into the back. Is this your usual way for this style drawer? I was planning to use a brass slotted screw in the same location. Any thoughts on yea or nay relative to using a screw?
Reply

#7
(05-23-2020, 09:29 PM)theoldfart Wrote: Derek, in the last pic it looks like the bottom is secured by nailing into the back. Is this your usual way for this style drawer? I was planning to use a brass slotted screw in the same location. Any thoughts on yea or nay relative to using a screw?

The rear of the bottom is not held by a nail, but a slot with a screw. The entire bottom slides into drawer slips. The dark wood is hard Jarrah for extra wear resistance.

See this page for a full example:  http://www.inthewoodshop.com/Furniture/D...Slips.html

Regards from Perth

Derek
Articles on furniture building, shop made tools and tool reviews at www.inthewoodshop.com
Reply
Drawer planing fixture


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.