#3
Experimenting with small bits on a CNC. This was done with two bits, a 3.175mm (1/8") and a 1.5mm (1/16"). Also experimenting with Milliput epoxy putty instead of a pourable type.

Alder, about 3" across.  Ultimately this is noodling ideas for some coasters so those will be larger at about 3.75" across. Just the material that was handy.

   

So far I'm not a big fan of the Milliput. The flash from the camera shows the slight alligator skin texture but just looking at it in room light, it is smooth and you don't see the texture. But i think the result I get with a pourable epoxy looks better. Maybe sand up past 320.
Don't sweat the petty things and don't pet the sweaty things. -- G. Carlin
Reply
cnc experiments


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.