#11
Hopefully it will turn out well.   This will be for a planned 2021 (formerly 2020) wedding couple:

   

   

   
Chris
Reply

#12
It was a rare day of very good luck...

I found some back slat pieces in my hoard that were exactly the right length, no cross-cutting required
Smile

[attachment=31280][attachment=31279]


I did a bit of re-proportioning on the shelf-tongue, and chose a different inlay.  Now it's wetted for color assessment:

[attachment=31281]


Happy Woodworking!
Chris
Chris
Reply
#13
It's done.   The wood is a little busy-looking so it will probably look better in use if stuffed with envelopes and recipes.    This is that rift-sawn tricky oak that was the starter of a different thread, plus some coffeetree scraps on the back.   Finish is a combination of hard wax and shellac.

Thanks for watching....

[attachment=31458]

[attachment=31459]

Chris
Chris
Reply
#14
Really looks nice.

BTW that is an interesting table under the valet.
"I tried being reasonable..........I didn't like it." Clint Eastwood
Reply
#15
Thanks, Bill!

On that table, which is my 'home office' desk, it was a project I did about 14 years back.  I think I was enjoying the 'pickled' or 'color stained' oak tables seen at Borders bookstores in those days.   I went for some reddish coloring, and messed part of it enough to add a sort of pizza-hut-logo overcoating pattern to the top.   Anyway, I also threw in a rotating drawer along with a usual drawer....

[attachment=31465]
[attachment=31466]


Chris
Chris
Reply
#16
It seemed like the gift needed a bit more to it.
I had another piece of very gnarly oak which I finally got planed to my satisfaction, having avoiding the problems for years.

I'm working on a little box; it's laid out basically and just needs fine-tuning now.


[attachment=31768]
Chris
Reply
#17
Here is the small valet to the valet...

It was basically a one-board box from very figured oak, but the bottom needed to be something really low-profile without a lot of work.  I stole some of bandit's spare cedar 
Smile :

[attachment=31874]


Then it all was together for a bit of finish:

[attachment=31876]
[attachment=31875]


Thanks for watching

Chris
Chris
Reply
#18
Beautiful figure, but from here, it sure looks more like walnut.
"I tried being reasonable..........I didn't like it." Clint Eastwood
Reply

#19
(12-29-2020, 08:32 AM)Bill Holt Wrote: Beautiful figure, but from here, it sure looks more like walnut.


Hi Bill,
    Understandable sentiment!  From the odor and the hardness, I have no doubt it's in the (white / live / post ?) oak family.  I did use some red-toned oil on it when finishing.

    Today I de-glazed the shellac a bit, so it's not quite so garish looking.

    I remember one of the Roy Underhill episodes, where Mr. Follansbee explained, "red oak is white, and white oak is brown"
Smile


Chris
Chris
Reply
Working on a Valet box


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.