Posts: 1,609
Threads: 0
Joined: Oct 2008
I'm about to start assembling some shaker style cabinet doors.
I always see the cabinet door clamp sets with two clamps going one way and the other two clamps going the other. I can see the reason to clamp the sides, but what is the reason to clamp it the long way? Keep the outside edges flush? Do you dare put the clamp on the joint and risk gluing your clamp to the door?
Posts: 13,485
Threads: 0
Joined: Oct 1999
I have made literally thousands of cabinet doors over the years. The ONLY time I wise clamps from rail to rail is to set things in place, nudge them into alignment. Usually, I apply a bit of stile to stile pressure and tap with a mallet and block.
Using two clamps per door means I can clamp twice as many at once!
Ralph
Posts: 12,858
Threads: 0
Joined: Jan 2010
Location: Lewiston, NY
Shaker style door made with Amana cope and stick router bit set.
Two clamps are all that's needed.
John
Posts: 805
Threads: 0
Joined: Feb 2003
Location: Land of Enchantment
+1. I usually make my stiles a bit on the long side and finish the top and bottom off on the edge sander after assembly.
Bob
Posts: 680
Threads: 0
Joined: Nov 2009
I only ever used two clamps total to assemble doors. I glue them up and put the door face down in the clamps. I tighten the clamps, check for square, clean the excess glue and put two pin nails from the back into each joint. I remove the door from the clamps and clean the glue squeeze out off the front and set it aside to dry. Repeat the process.
"...cuttin' your presidency off right now. Just quit. Because if this is you helpin' us, then stop helpin' us."
Posts: 5,733
Threads: 2
Joined: Dec 2004
Location: Fort Worth
BobW said:
+1. I usually make my stiles a bit on the long side and finish the top and bottom off on the edge sander after assembly.
Same here but I have also made the rails wider on a few occasions and just trimmed the whole panel to size afterwards. Saved me from remaking a door here and here too cause of a goofy cab etc.
Posts: 558
Threads: 0
Joined: Oct 2008
Were they possibly mitered corner doors you were seeing clamped ?
Posts: 24,145
Threads: 2
Joined: Sep 2003
Location: Missouri
AlanBienlein said:
I only ever used two clamps total to assemble doors. I glue them up and put the door face down in the clamps. I tighten the clamps, check for square, clean the excess glue and put two pin nails from the back into each joint. I remove the door from the clamps and clean the glue squeeze out off the front and set it aside to dry. Repeat the process.
+1
Steve
Mo.
I miss the days of using my dinghy with a girlfriend too. Zack Butler-4/18/24
The Revos apparently are designed to clamp railroad ties and pull together horrifically prepared joints
WaterlooMark 02/9/2020
Posts: 1,609
Threads: 0
Joined: Oct 2008
Leinie said:
Were they possibly mitered corner doors you were seeing clamped ?
Could have been. Here's an image for fodder:
Posts: 558
Threads: 0
Joined: Oct 2008
Ok, it's not a mitered corner door- just standard stile and rail
Raise your hand if you do your edge profile before glue up ?
Evidently the guy with that clamp setup does.
