Posts: 1,644
Threads: 0
Joined: Apr 2006
I have a very old Incra V-27. I have a rigged aluminum fence (it is accurate but a pain to measure sometimes).
It was originally used on a Unisaw. I have since replaced the Uni with a Sawstop PCS.
I want to either buy an Incra fence and the flip shop stop and add to this or just buy a new 1000-SE or other miter gauge that would include the Incra fence and stop.
Recommendations?
Posts: 270
Threads: 0
Joined: May 2005
(10-06-2017, 04:49 PM)Chuck in NC Wrote: I have a very old Incra V-27. I have a rigged aluminum fence (it is accurate but a pain to measure sometimes).
It was originally used on a Unisaw. I have since replaced the Uni with a Sawstop PCS.
I want to either buy an Incra fence and the flip shop stop and add to this or just buy a new 1000-SE or other miter gauge that would include the Incra fence and stop.
Recommendations?
Chuck, definitely not a pro, but in a similar situation, I bought a new 1000-SE. Used the original one as a dedicated 45* miter gauge.
Steve
Posts: 1,685
Threads: 0
Joined: Apr 2005
(10-06-2017, 04:49 PM)Chuck in NC Wrote: I have a very old Incra V-27. I have a rigged aluminum fence (it is accurate but a pain to measure sometimes).
It was originally used on a Unisaw. I have since replaced the Uni with a Sawstop PCS.
I want to either buy an Incra fence and the flip shop stop and add to this or just buy a new 1000-SE or other miter gauge that would include the Incra fence and stop.
Recommendations?
It can be useful to have more than 1 miter gauge. I use one on a band saw, router table, TS box joint jig etc. etc. Leave one set up for the table saw.
Posts: 5,653
Threads: 0
Joined: May 2005
Location: Centre County Pennsylvania
I use my original PM 66 gauge all the time in addition to my incra. Cannot for the life of me figure out why the OEM gauge squeals so bad, so I was thinking about getting another incra. I would probably get a 1000 SE again, although the V27 might work better as a second gauge
Posts: 2,497
Threads: 0
Joined: Oct 2005
I have the 1000HD for the table saw. I have a V27 that I move around other tools like the bandsaw.
"There is no such thing as stupid questions, just stupid people"