"The space efficiency of pure chaos is hard to beat"
#10
I always enjoy the woodgears.ca site, but today's entry was particularly entertaining. It seems drawer bottoms are likely strong enough, no matter what approach you use for them. I also like his conclusion that I've used as a thread title.
Reply
#11
It was an interesting read. We woodworker's get all tied up in knots over the strength of something, whether it's biscuits, or clamp pressure, or maybe drawer bottoms...when in truth they are probably work well enough for what we are doing.
I started with absolutely nothing. Now, thanks to years of hard work, careful planning, and perseverance, I find I still have most of it left.
Reply
#12
I'd sure like to see that test done with 1/4 Baltic Birch bottoms.
Alaskan's for Global Warming
Eagle River AK
Reply
#13
I'd usually more concerned on aesthetics of the drawer than strength of how the bottom is secured.

Try using a glued on the bottom drawer bottom with Blum Tandem slides...

But I have done the glued on the bottom drawer bottoms before.

Reality is that which, when you stop believing in it, doesn't go away. - Philip K. Dick

Mark

Reply
#14
Same here. It's really the looks of the drawer and the style of slides that dictate you away from just gluing the bottoms on. You also gain a little drawer depth. I always make drawers as big as I can fit to use all the space provided.

I did like that quote too..
Reply
#15
I like flat bottoms because stuff from the next drawer down can't stick up and catch.

Just made 10 drawers for the van. I used 1/2" ply bottoms with rabbet in a groove. Waaay overkill.
Carolyn

Trip Blog for Twelve Countries:   [url=http://www.woodworkingtraveler.wordpress.com[/url]

"It's good to know, but it's better to understand."  Auze Jackson
Reply
#16
If you're going to just use regular wood runners (instead of drawer slides) how well is plywood going to hold up at the new contact point of a drawer runner? For that type of design I usually use at least poplar for sides.

Interesting side note----I built an end table and matching coffee table with somme small drawers. I groved around all four sides and trapped my plywood bottom.

Flash forward a couple years----drawer was open and I knocked over a large glass of water, with most going in the drawer. After I rushed to empty the drawer contents, the water was still holding. Tight as if it were a plastic tub---just dumped the water and let the draw dry out.
Dave
Reply
#17
Drawer slides. K&V8400RV. They have a spring to keep them closed while driving. A bit hard to open, actually, but that's OK.
Carolyn

Trip Blog for Twelve Countries:   [url=http://www.woodworkingtraveler.wordpress.com[/url]

"It's good to know, but it's better to understand."  Auze Jackson
Reply
#18
Yep, glue is strong. I'm thinking he does this for shop drawers and not for high end cabinetry. Aesthetics does matter.
Still Learning,

Allan Hill
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.