Band saw resaaw problems
#11
I have the Griz 513 extreme with a 1/2" blade. When I try to resaw some QS red oak, it will not track. Not even remotely. If I try to do it free hand, ie without the fence, the blade belles out to the right and through the piece. With the fence, the drift angle is beyond the fence drift settings, like more than 5 degrees. It starts out OK the cuts a wedge instead of a parallel slice. Everything is aligned for tracking.

Is the blade dead?? Thanks, Tom
Reply
#12
Is the blade dead??

could be. how much use has it seen? what brand is it?

Could also be under tensioned (a fairly common occurrence)

don't believe the tensioner on the back of the saw, they tend to lie, and I would skip the flutter method as well.

You need more tension not more ways to prove you do not have enough

Joe
Let us not seek the Republican Answer , or the Democratic answer. Let us not seek to fix the blame for the past. Let us accept our own responsibility for the future  John F. Kennedy 



Reply
#13
I have the same problem after installing a brand new Timberwolf blade. No matter what I do it will not cut straight. I contacted PS Wood Machine and they told me it's most likely I bought a faulty blade. They replace it free of charge.
Reply
#14
Where are folks getting their blades these days?? Thanks, Tom
Reply
#15
woodcraft bands....

Lenox and Starret brand blades which are as good as you can buy

you will have to call the 800 number and talk to an actual person who will assist you if you want information.

Except on Fridays he takes that day off

Joe
Let us not seek the Republican Answer , or the Democratic answer. Let us not seek to fix the blame for the past. Let us accept our own responsibility for the future  John F. Kennedy 



Reply
#16
I got the Timberwolf at Woodcraft. Then I mail order some at bandsawblades.com.
Reply
#17
Call 888-778-WOOD talk to him about your saw, and what you want to do. He'll get you fixed up.

Or go to

this page and a "have a question" balloon will pop up. No charge for free advice......
Worst thing they can do is cook ya and eat ya

GW
Reply
#18
Steve N said:


Call 888-778-WOOD talk to him about your saw, and what you want to do. He'll get you fixed up.

Or go to

this page and a "have a question" balloon will pop up. No charge for free advice......




+1 on Cyber Woodworking Depot. Great blades and great advice.
Reply
#19
What kind of blade? Resawing requires a blade with very few teeth, like 3 or 4 for a 1/2" blade. Drift is caused by a blade that's not positioned properly on the wheels or wheels that aren't close to co-planer, a blade that doesn't have equal set on both sides, or is dull on one side. A belly in the blade could be due to too little tension, or most of what I said above.

John
Reply
#20
The blade may not be dead, but it's likely dead for resawing unless resharpened. A bandsaw blade used for resawing needs to be sharper than one used to cut thinner materials, as explained here. He also shows why tension helps.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.