Thrust bearing replacement delta 14"bandsaw?H
#6
Have model 28-255 and cannot figure out how to remove lower thrust bearing. Have removed screw on rod holding shaft that holds bearing but not enough room to slide shaft all the way forward. Any tips? Thanks...Bill
Reply
#7
Do you have a 3 jaw puller?Should pull off fairly easy.
mike
Reply
#8
It's not stuck on shaft. The problem is lack of room to remove shaft n bearing.
Reply
#9
Take the whole assembly apart. Good time to clean it. 2 large screws hold it to the table bracket.
Reply
#10
Got it done. Found best to remove table which gave much better access.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.