Another what is it (pics added)
#11
OK, I know it's a breast drill. Other than that, nothing. Appears to missing something where there is button and then an empty hole. Is that missing part what I need to change gears? If not then how do I do it?

Value? I'd flip if valuable but would otherwise use. Came with a Lennox hole saw in the chuck - which works.

Tia
Thanks,  Curt
-----------------
"Life can only be understood backwards; but it must be lived forwards."
      -- Soren Kierkegaard
Reply
#12
Pics Curt, or am I missing something.
Jim
http://ancorayachtservice.com/ home of the Chain Leg Vise.
Reply
#13
oops



Thanks,  Curt
-----------------
"Life can only be understood backwards; but it must be lived forwards."
      -- Soren Kierkegaard
Reply
#14
I'm trying to picture it in my mind, but all I'm getting is an old rusty saw...
Catchalater,
Marv


I did then what I knew how to do. Now that I know better, I do better.”
― Maya Angelou

I'm working toward my PHD.  (Projects Half Done)
Reply
#15
That hole is for the shaft that's on the big drive gear. There should be a release button or something that releases the big gear so you can pull it out, then stick it in the empty hole. This will change the speed.

As to value.... not much... guessing around ten dollars. Looks to be in good condition though. It will clean up quite well. The side handle looks like it's taped?

Catchalater,
Marv


I did then what I knew how to do. Now that I know better, I do better.”
― Maya Angelou

I'm working toward my PHD.  (Projects Half Done)
Reply
#16
If I remember correctly, the main gear is removable to change speeds. You press the button to remove it from the hole it's mounted in, and place it in the empty hole. That causes it to mesh with the smaller set of gears on the spindle and gives you the slower speed.
I would guess the value to be $35.00-$45.00.
Rick W
Reply
#17
That silver button between the holes releases the shaft to move it to the other hole. As everyone said it is for changing the gear ratio.
Jim
http://ancorayachtservice.com/ home of the Chain Leg Vise.
Reply
#18
Thank you gentlemen. Now who made it? Is that old Massey-Ferguson red paint on there?
Thanks,  Curt
-----------------
"Life can only be understood backwards; but it must be lived forwards."
      -- Soren Kierkegaard
Reply
#19
Clean up the crank arm and you should find the manufacturer.
Jim
http://ancorayachtservice.com/ home of the Chain Leg Vise.
Reply
#20
Goodell Pratt (probably a #246)
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.