FS: Drawknives, chisels, more added

[SteveF]

Several nice drawknives.

There's a 6" Hart Mfg., a 7" C.J.Kimball, a 8" AST(Germany), and a 10" Greenlee. The only one I ground the edge on is the Kimball, all just need honing.  Tight handles on all, no problems.

6" $35
7" $30
8" $30
10" $35

[SteveF]

Handyman Club of America 7 piece chisel set. They look to be unused. The 1/4" edge is dinged up though, probably dropped.

$20 plus shipping






Marples 2033 marking gauge. This uses a wedged cutter.

$15 plus shipping

[SteveF]

Rockwell 6302 HD Motor with the 6301 base. Runs great, the bearings sound good. This has the 1/4" collet, the 1/2" is readily available (Porter Cable).

$50 plus shipping

[SteveF]

Stanley No.10 carriage plane. Nice old one with most of the original jappaning. I repaired the tote (broken in half). The iron is getting down to the end, but will probably last quite a bit longer. 

$85 plus shipping

[SteveF]

The 6" Hart and 7" Kimball drawknives have been sold.

[SteveF]

4" drawknife. Unmarked, but it's in the Jennings style. I cleaned it up and ground a new edge, just needs honing. The handle tend to get loose on these. I reinstalled the handles and used JB Weld, they ain't coming off.

$30 plus shipping




Stanley 8" bevel.  It has nickle loss and a couple of spots of pitting, still way nicer than the one I use at work. Itlocks tightly, no problems.

$12 plus shipping

[SteveF]

Sandvik card scrapers. Unused, a few spots of corrosion. I have 2 of these.

$5 apiece plus shipping







North Bros. Stanley 433H spiral screwdriver. Works great, 3 bits.

$10 plus shipping

[Boatman53]

Steve, PM sent.
Jim

[SteveF]

Sold so far:

Hart Mfg. 6" drawknife

C.J.Kimball 7"drawknife

4" drawknife

Marples marking gauge

Both Sandvik scrapers

[professore]

PM on cutting gauge and scrapers.

Frank S in IA