08-08-2017, 01:15 PM (This post was last modified: 08-08-2017, 10:43 PM by Splinterz25.)
[attachment=3653][attachment=3653][attachment=3653][attachment=3653][attachment=3653][attachment=3653][attachment=3653][attachment=3653][attachment=3653][attachment=3653][attachment=3654][attachment=3654][attachment=3654][attachment=3655][attachment=3655][attachment=3656][attachment=3656][attachment=3656][attachment=3656]Hello Everyone this is a piece I did awhile ago 6" tall 10" D at the top. This is how the planks were laid up in a long strip w/ each color cut at a 45 degree, then after planing smooth they were cut into wedges. This was the tricky part getting the wedge angle and the lean of the wedge to give an equal spacing between each. After that the holes were board and every part that could never be reached was sanded to 320 grit, then the final glue up was done. It was very tricky to turn because of the large hole and even harder to sand. I had to make a sanding block out of dense foam that matched the inside curve.
Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.