Saw question
#15
(09-13-2017, 03:47 PM)Angus Wrote: Arlin, it doesn't matter if the blade is completely vertical, but it is a perfect 90 degrees to the top of the sled.

That is what I was meaning sorry
As of this time I am not teaching vets to turn. Also please do not send any items to me without prior notification.  Thank You Everyone.

It is always the right time, to do the right thing.
Reply
#16
I used a thin kerf on my CMS one time years ago. First time I tried it on a 1.5" African blackwood square. It deflected badly so that I deemed it to be unreliable for very hard woods. Put it back in the packaging and took it back. Have only used standard kerf since then.
Cellulose runs through my veins!
Reply
#17
Get a full size blade for segments. You could try sharpening it but it still may deflect. You can use a disc sander to square them up but it's a pain.
Don
Reply
#18
I use the thin kerf for the same reasons, I also use stabilizers.  Have not noticed any problems when the blade was sharp.
"I tried being reasonable..........I didn't like it." Clint Eastwood
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.