Posts: 2,192
Threads: 1
Joined: Oct 2003
Would suggest glue and some other mechanical fastener. Since it is concrete, I think code requires treated lumber or a barrier. Treated is easier, but then you have to make sure you use an approved fastener. Construction adhesive takes care of that. Should the mechanical fastener corrode, the adhesive is still there.
Posts: 23,917
Threads: 2
Joined: Sep 2003
Location: Missouri
Best and easiest doesn't fit together well sometimes.
I go with tapcons.
Steve
Mo.
I miss the days of using my dinghy with a girlfriend too. Zack Butler-4/18/24
The Revos apparently are designed to clamp railroad ties and pull together horrifically prepared joints
WaterlooMark 02/9/2020
Posts: 20,865
Threads: 1
Joined: Sep 2003
Location: Sioux Falls SD
(11-10-2017, 03:26 PM)Stwood_ Wrote: Best and easiest doesn't fit together well sometimes.
I go with tapcons.
i Concure with the adhesive along with concrete screws or powder actuated fasteners. Since the walls are small and there is a doorway involved and old concrete, the adhesive will help hold it secure.
WoodNET... the new safespace
Posts: 38,308
Threads: 0
Joined: Feb 2002
Location: Northern California
You want it to be there forever then use Simpson Titen's. Otherwise what the other guys said.
Reality is that which, when you stop believing in it, doesn't go away. - Philip K. Dick
Mark
Posts: 12,451
Threads: 0
Joined: Aug 2003
Location: Wapakoneta, OH
Hadn't seen you around lately, Mark. Good to see your post.
I started with absolutely nothing. Now, thanks to years of hard work, careful planning, and perseverance, I find I still have most of it left.
Posts: 38,308
Threads: 0
Joined: Feb 2002
Location: Northern California
Too much real life going on
Reality is that which, when you stop believing in it, doesn't go away. - Philip K. Dick
Mark
Posts: 63,414
Threads: 3
Joined: Feb 2007
Location: Merryland
I usually build my walls laying down and stand them in place. A little construction adhesive on the bottom and drive a couple cut nails in. The don't have to go in very far. Just enough to keep the bottom from sliding. That being said, I wouldn't use 2x3s. Much easier to build straight walls with 2x4s. Even easier with steel studs where I'd use the ramset.
Posts: 4,438
Threads: 0
Joined: Jan 2005
(11-10-2017, 08:19 AM)fixtureman Wrote: When we don't have a Ramset on hand we do that way jsut a piece of wire or nail and then pound in another nail
Even if I had a Ramset on had I would drill a 3/16" hole , drop in a 4" length of tie wire and pound a galvanized 16d nail thru. Done properly, the nail would stay if the plate was pried off. Galvanized nails would be best but not a necessity on a basement floor.
mike
Posts: 11,619
Threads: 0
Joined: Jan 2005
Location: North Central Illinois
I have done several with Tapcons and have been happy with the results
