Woodnet Forums › › Active › Woodworking Power Tools v
And then it went BANG
Thread Modes
And then it went BANG
EricU Offline
Member
Posts: 5,651
Threads: 0
Joined: May 2005
Location: Centre County Pennsylvania
#32
10-05-2018, 07:11 PM
blades are all welded.  All carbide blades are welded after the teeth are brazed on, so there must not be a problem

The welders pass electricity through the band fairly close to the weld and the heating is very localized.  The braze probably doesn't even notice.
Find
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.