Start of something small
#17
  Re: Start of something small by bandit571 (for a change.   A si...)
The joys of being Retired.....I work only as much as i feel like, when I feel like it.... Cool

So....maybe a PIP, since I now have a coat of Poly Gloss on this little table? Winkgrin   
   
Center view..not sure which way will be the "front" Confused  
   
Maybe this one? Rolleyes 
   
Or this one?

Just one coat, so far
Show me a picture, I'll build a project from that
Reply
#18
  Re: Start of something small by bandit571 (for a change.   A si...)
One coat was just enough.  Table is done.  Other than rehabbing a couple chisels from recent rust hunts, not much going on.  Out of lumber, at the moment No 

Well, there are three 2 x 10 x 24" slabs sitting around, and a 1/2" x 2' x 2' maple plywood panel...not really enough to do much of anything with....yet.

Chisels being rehabbed? Confused  
   
Defiance by Stanley.  1-1/2" wide.   Needed a new handle. 
And last night's foray.. Winkgrin  
   
Needed a new edge done.  Old one was skewed, and at a 40+ angle for a bevel   Raised 
   
Crescent Tool Co. No. 175    1  1/4   Made in Jamestown N.Y., USA

More for Plumbers and Electricians..
   
I even repainted the red end, after removing the old Mushroomed part Winkgrin  
   
Was part of a large tub of tools I picked for $5...Chisel is setting bevel down in that  photo, shadows showing up. 

Waiting on either a new stash of Lumber, or the next Rust Hunt trophy.... Rolleyes
Show me a picture, I'll build a project from that
Reply
#19
  Re: Start of something small by bandit571 (for a change.   A si...)
What wood was it for the table top?  Also another project well done buddy.
It is always the right time, to do the right thing.

Hi, I'm Arlin's proud wife! His brain trma & meds-give memory probs and has pain from injuries, but all is well materially & financially.  
Reply
#20
  Re: Start of something small by bandit571 (for a change.   A si...)
Table's top was just Pine from Menard's.....they had a pallet of what they called "Quality Boards" that had been cut to 4' lengths, I picked through and found an interesting one, that didn't have a bunch of knots.    Just a 1 x 10 x 48"....Made a pair of 1 x 10 x 24" pieces, and bookmatched them.... Winkgrin
Show me a picture, I'll build a project from that
Reply
#21
  Re: RE: Start of something small by bandit571 (One coat was just en...)
(06-07-2018, 11:57 AM)bandit571 Wrote: One coat was just enough.  Table is done.  Other than rehabbing a couple chisels from recent rust hunts, not much going on.  Out of lumber, at the moment...

Very nice. I do enjoy seeing your project posts.  Thanks for sharing.
Reply
#22
  Re: RE: Start of something small by Cian ([quote='bandit571' p...)
(06-11-2018, 12:15 PM)Cian Wrote: Very nice. I do enjoy seeing your project posts.  Thanks for sharing.

Yes... excellent work.. Thanks!
Skip


Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)