Small engine question.
  Re: Small engine question. by PedroOhare (i was going to make ...)
Take carb apart and clean, take it easy with any gaskets so you can use again and have a can of spray starter fluid to spray in carb when try to start if runs for a minute and cuts off, not getting gas or something else is wrong, but this will get you started in the right direction.
Finishing: I apply shellac before I apply varnish.
Routing:Hand Left to Right, Table right to left
Cutting plywood:Face up on the table saw
Face down w/circular saw.
Wear safety glasses when using power tools.


Forum Jump:

Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.