Quest machine found! 12" Clement jointer
#42
I added a dust chute and pulled the cutterhead from the machine.  Two cleats are screwed to the inside of the base.  1/2" ply sits on top.  1/4" ply ramps will hopefully help direct chips down.  Rockler Dust Right fitting and elbow.

There are four bearings total, two on each side. Bearing is labeled 6206RS1.  I've reached out to Accurate to spec out equivalent self aligning bearings.


Attached Files Image(s)
   
   
   
   
Semper fi,
Brad

Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.